PD2500 Series User’s Manual
Stand-alone Pole Display with a mount plate and small base size with a rock power ON/OFF switch on base (PD2500). Rear mount Pole Display for Posiflex Jiva XL series touch terminals (PD2501) Euro dollar sign supported in code page 858 Various command emulation modes selectable by DIP switch Total height 556mm above mounting plate with a strong, stable pole 0° to 45° tilt in four steps and 300° swivel for best viewing effect Cabinet color choices: ivory, charcoal.
INSTALLATION
1. For all PD2500 & PD2501: Please set DIP SW on back of the display unit of PD2500/PD2501 according to the appropriate emulation mode and the instructions in next section.
2. For all PD2500: Mount the pole display stand plate to the metal plate of base cabinet with screws and mount the pole display stand plate to the bottom of your Posiflex cash drawer CR3100/CR3200 series as in the drawing or on the cashier’s dash. Connect the pass through device to 9 pin male connector at side of PD2500 base if required. Stand plate Bottom view of cash drawer Base cabinet
3. For PD2500 with power adaptor only: Use the attached interface cable 20863035900 (CCBLA-359) to connect the 9 pin female connector at side of the base of PD2500 to the 9 pin male connector for serial port such as COM1 of the host PC. Check the specification of power adapter on its nameplate. Check the power switch on base of PD2500 should be turned off. Insert the power adaptor into the right power outlet. Insert the output plug to the jack above the 9 pin D connector at one side of PD2500 base.
4. For PC powered PD2500 only: Open the case of a PC per its instruction manual. Take the attached assembly coded 20867014100 (or known as CCBLA-141) and install the I/O plate to one of the I/O windows in PC. Then connect it to one of the power connectors from CCBLA - 141 4 pin power connector from switching power supply unit.
Get pdf PD2500 Series User’s Manual
