HP 130 designjet NR Printing Guide
Initial Set-Up Procedures - Pre-Sets
Your FineArtPrints representative will set up your defaults and printing pre-sets when installing your Cinemage 200 system. However, if something should happen to your operating system or the pre-sets are changed somehow, this information sheet will guide you through the basics of restoring the proper system defaults for print production.
Default Printer Settings
1. Click on the Start button and Select Control Panel from the Start-up menu
2. Click on Printers and Faxes and Double Click on the HP 130 designjet NR icon
3. Click on Printer and Click on Properties
4. Select Printing Preferences
5. Under the Paper/Quality Category Tab:
a. Set the Source is to Roll
b. Set the Print Quality to Best
c. Click the Advanced Paper Settings button
i. Select Autorotate
ii. Set Roll Size to 24”Roll
6. Click OK on the Bottom Toolbar
7. Right Click on the HP 130 designjet NR Printer Icon and set as default Printer
8. Close Dialogue box, accepting all changes
Default Page Sizes
If these should be deleted somehow, you will have to contact your FineArtPrints representative and have them restored. There may be a programming fee if this should happen so be careful not to alter or delete them.
Get pdf HP 130 designjet NR Printing Guide
