Express All-Fiber DVI User’s Manual (For M1-1000)
The M1-1000 is designed for its Tx module to use +5V internal power supplied through a DVI pin (#14) from the graphic card. For ease of use or safety, the Tx module has a power auto-switching circuit to protect from plugging the external power while powering through DVI pin from the graphic cards. However, its Rx module requires one external +5V AC/DC power adaptor to drive. To plug the power into one of two modules makes the other supplied over the hybrid cable.
Installation
Important: Please use the installation procedure below. Improper, or no operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Connect an AC/DC power adapter to the Rx module of M1-1000. Connect another power adaptor to the Tx module, when your video controller or graphic card doesn’t supply sufficient DC power through DVI connector.
Note: In most cases, the Tx module could be run by the power +5V supplied through a DVI pin (#14) from the graphic cards. After completing the installation instruction, if the system doesn’t work properly, you have to confirm the power capable to supply more than 200mA.
Step 3
Plug directly the Tx module of M1-1000 in the DVI receptacle of PC. Do NOT use any intermediate cable or adapter between them. Figure 2 – Tx Module of M1-1000 Cable 1-3 Installation
Step 4
Plug the Rx module of M1-1000 in the DVI receptacle of display. Do NOT use any intermediate cable or adapter between them
Get pdf Express All-Fiber DVI User’s Manual (For M1-1000)
