Druid Electric Fence Energizer Installer Manual
The DRUID is a battery (12V 7AH nominal) operated energizer suitable for connection to mains (230V 50Hz nominal). The batteries to be used are rechargeable lead-acid batteries. Non-rechargeable batteries must NOT be used. The lead-acid batteries require venting and it is imperative that the energizer be situated in a well-ventilated area.
Mounting / Battery Replacement Procedures
STEP 1: Disconnect mains. Open the lid by removing the two cap screws. Unplug the battery terminals if connected.
STEP 2: Remove screws and battery bracket
STEP 3: Remove battery
*Dispose of old battery according to legal requirements.
Do NOT replace with non-rechargeable battery!!
STEP 4: Drill 4 x 8mm holes for mounting the unit, use the template provided with the unit. Four nail-in anchors are also supplied with the unit. Insert the plastic sleeve of the nail-in anchor from the inside of the box and then hammer the screw in with a screw driver and hammer.
NB: Always insert the plastic sleeve from the inside of the box.
STEP 5: Insert battery with the positive terminal to the top.
STEP 6: Place the battery bracket back (with plastic offsets at the top) and fasten the screws.
STEP 7: Connect battery wires. Close the lid by hooking the top of the lid in first and then fasten the bottom down with the two cap screws. Apply mains to the unit.
Get pdf Druid Electric Fence Energizer Installer Manual
