UHF Reader/writer with 1-2 antennas support Instructions Manual
RS232 port
It is used to communicate with PC
RS232 format : 8 data bits, 1 start bit , 1 stop bit , none-parity bit
Baud rate : 9600,19200,38400,57600 and 115200
RJ45 port
It is used to communicate with PC and network system
- use patch Ethernet cable if connect the reader with Hub
- use crossover Ethernet cable if connect the reader with PC
Tag operation – ISO18000-6B
• multi-tag identification : search all the tags in the reading range to read the 8 byte UID
• multi-tag reading: search all the tag in the reading range to read the 8byte data from the beginning of the defined address
• single tag writing: write one byte data on the defined tag’s address
• single tag Lock: lock up the data on the defined address to prevent over-written
• Query Single tag locking : Query the locking state of the defined address.
Tag operation - EPC GEN2 (ISO18000-6C)
• multi-tag identification: search all the tags in the reading range to read the EPC data (96 bits)
• Single tag initialization: Initial the EPC data length of the tag (normally 96 bits)
(For a new EPC G2 tag, it must be initialized and pre-programmed to be read.)
• Single tag writing: read the EPC data of the tag, 16 bits for each time.
• Single tag locking: lock the EPC data of the tag to prevent data over-written.
Reader Parameter Configuration
[1] connect the reader with PC through RS232 ,
[2] connect external antenna with the reader
[3] apply power and power on the reader
[4] Run config program from path:\\CONFIG\config.exe
[5] select the com port setting and click on “Connect”
Get pdf UHF Reader/writer with 1-2 antennas support Instructions Manual
