CAUC Series User’s Manual
Follow the steps below to successfully set up your Cavalry External Hard
Drive with your computer.
Step 1. Start your computer and wait for Windows to load completely.
Step 2. Connect the power adapter to the drive. (Fig. 1)
Then plug the power adapter into an electrical outlet
Step 3. Connect the square end of the USB cable to the hard drive. (Fig. 2)
Then connect the flat end of the USB cable to the USB port on your computer
Step 4. Turn the power switch on.
NOTE: Connect the USB cable to the drive before connecting the cable to the computer. To disconnect, remove the cable from the computer first.
Step 5. Installing drivers for the Cavalry External Hard Drive.
Windows 2000/XP/Vista
Plug-and-play. No device drivers or configuration required. The computer will detect the USB External Hard Drive as a new USB device and display messages on the bottom-right corner reading “USB Mass Storage Device Detected” and “Your new hardware is installed and ready to use.”
Windows 98/Me
1. Make sure Windows 98/Me is fully updated
2. Go to www.cavalrystorage.com/su_download.htm and click on “Windows 98 Driver” to download the driver. Extract the file.
3. Navigate the device manager.
4. Right-click on the yellow question mark indicating an unknown
Get pdf CAUC Series User’s Manual
