VoomPC-2 Automotive PC Enclosure Mini-ITX Car PC Enclosure Installation Guide
Please take a moment and read this manual before you install the VoomPC-2™ in your vehicle. Often times, rushing into unit installation can result in serious damage to your motherboard, power supply and probably your car’s electrical system. The VoomPC-2 has a wire harness that needs to be connected to the car’s electrical system. During installation, always double check the polarity using a voltmeter.
The VoomPC-2 was designed to work with a wide variety of main boards such as the VIA mini-ITX boards as well as low power Pentium-M OR Core 2 Duo. Please note that powering full power P4 or AMD systems is not recommended due to excessive heat dissipation.
Required tools
In order to install the VoomPC-2 in your vehicle you will need the following:
-Phillips screwdriver and Wire cutter / stripper
-Few feet of wire (AWG 12-16), preferably color coded, used for power input.
VoomPC-2 installation steps
1) Install the motherboard, Front Audio / USB board and Power Supply on the base plate using M3 screws. (See figure 1.0)
2) Connect the ATX cable harness provided with your power supply to the motherboard. NOTE: Use small tie-wraps on the ATX cable harness in order to improve air flow.
Get pdf VoomPC-2 Automotive PC Enclosure Mini-ITX Car PC Enclosure Installation Guide
