Nextiva S2600e Series Installation guide
This installation guide provides instructions for installing and performing the initial configuration of the Nextiva TM S2600e series IP cameras. It covers the S2600e, S2600e-AS, S2610e, and S2610e-AS. For more information on specific configuration, accessing and using the web interface, and other aspects of the product, refer to the Nextiva S2600e Series User Guide
Installation
The installation steps are:
1. Installing the camera and the lens
2. Configuring the device
3. Adjusting the image
4. Fine-tuning the image
Installing the Camera and the Lens
1. Remove the caps in front of the camera and on the lens.
2. Check that the locking screw of the back focus ring is fastened.
3. For a C-mount lens, install a C-to-CS lens adaptor (not supplied by Verint) on the front of the camera.
4. Screw the lens on the back focus ring.
5. If you are using an auto-iris lens, insert the auto-iris plug into the connector on the back of the camera.
6. Connect the camera to the network and power it. If you are using the 12V DC power supply or PoE kit provided by Verint, refer to the user guide for the procedure. Otherwise, read the documentation of the power supply or PoE kit.
7. Install the camera at its final location, using the mounting hole at the bottom of the camera. Install the S2600e-AS and S2610e-AS in an upright position. The S2600e and S2610e cameras can be installed upright or upside down.
Get pdf Nextiva S2600e Series Installation guide
