Cinema3D Card User’s Manual
This is an interface card to for Stereo 3D Synchronization. Basically, it must be equipped with a VGA cable which is directly connected to the PC VGA port to process the stereo 3D video signals which are a couple of possible 3D image formats(i.e. “Page-Flip” and “Above/Below”). Then its controller will automatically convert these 3D formats into stereo 3D synchronization signals for infrared transmitter.
VGA-SYNC
This is a 9-Pin DIN-Jack for connecting your display graphics card with the attached VGA cable to get the video signals.
VGA-OUT
This is a 15-Pin D-Sub connector for connecting your DLP projector.
VR-OUT
This is an output port for supporting i-Art’s Wired LC Shutter Glasses (Optional).
IR-SYNC
This is the Stereo-Sync output port for connecting the Infrared Emitter Unit with RJ11 cable.
SYNC-SWAP
If you find the Stereo-Sync in reverse with Infrared LC Shutter Glasses, then you can set the SYNC-SWAP switch to either Up or Down side to swap the synchronization sequence of Left/Right for each LC Shutter Glasses to avoid the “Pseudo Stereo” effect.
Power Connector
With the attached Power Cord, you may connect the PC power to it.
Get pdf Cinema3D Card User’s Manual
