TELTONIKA ModemCOM/G10 (CM100) User Manual
The PC and power supply source, to which the device “ModemCOM-TM2” is connected should satisfy LST EN 60950-1 standards. The device can be used with the first (Personal Computer) or the second (Notebook) computer safety class. In the installation place and supply circuits the protective devices should be tooled up (bipolar release device) which will protect the device from short-circuit and grounding troubles (Picture 1.1). The power of the release device should satisfy the power of connected to it devices. The interstice between release contacts should not be less than 3mm. The power supply network should be installed near device on easily accessible place.
Full disconnection of the device is performed by pulling out the constant current DC plug from the device. Data transfer cable for connection to another device must not be shorter than 2 meters.
Maintenance of the device:
If the device starts working faulty only qualified personnel may repair this product. We recommend dismantling the device and forwarding it tit repair center or to manufacturers. No exchangeable parts in the device.
This document will provide you with the instructions how to install and use ModemCOM/G10“ and its software. „ModemCOM/G10“ is a device designed for data transmission via GSM Network. The design of this modem enables the connection to your PC through COM interface. „ModemCOM/G10“ supports the following data-bearers: GPRS, CSD, CSF and SMS.
Get pdf TELTONIKA ModemCOM/G10 (CM100) User Manual
